How to Fix Error 1114 in CS2: A Step-by-Step Guide

Are you facing Error 1114 while using Code::Blocks IDE in C++?

If so, you’re not alone. This error can be frustrating and time-consuming to fix, but don’t worry – we’ve got your back. In this article, we’ll take a closer look at what Error 1114 is and how you can fix it quickly and easily.

Error 1114 is usually caused by a missing or corrupted DLL (Dynamic Link Library) file. This can happen for a number of reasons, such as upgrading your operating system or installing new software. To fix Error 1114, you need to find the missing DLL file and replace it with a valid version.

Here’s how to do it:

Step 1: Open File Explorer and navigate to the “C:WindowsSystem32” folder. Look for a folder called “dllfiles”.

Step 2: In the “dllfiles” folder, look for a file called “msvcr90.dll”. This is the DLL file that’s causing the Error 1114.

Step 3: Right-click on the “msvcr90.dll” file and select “Properties”. In the Properties window, click on the “Compatibility” tab.

Step 4: Under “Compatibility mode”, make sure that “Run this program in compatibility mode for:” is set to “Windows XP (Service Pack 3) or later”.

Step 5: Click “OK” to save your changes and close the Properties window.

Step 6: Restart Code::Blocks IDE and try running your code again. If Error 1114 persists, repeat steps 2-5 with other DLL files in the “dllfiles” folder until you find a valid version of the missing file.

By following these simple steps, you should be able to fix Error 1114 and get back to coding without any further issues. If you continue to experience problems, it’s always a good idea to consult with a qualified software engineer or contact Code::Blocks support for further assistance.